![]() Test by entering the PIN and pressing the UP/DOWN arrow key once.The initial setup is quick and easy, it takes only. While the purple light is blinking (30 seconds), go to the keypad, enter the new code you programmed into the keypad, and slowly press and release the UP/DOWN arrow key several times until the door activates. This genie wireless keypad includes the added security of Genie Intellicode Technology built right in.Upon releasing the square button, the blue light will turn off and the long purple button will start to blink.Press and hold the square PROGRAM button (shown in the diagram above) located on the bottom of the motor head, until the round LED turns blue and release the button.Enter your PIN ( from three to eight characters).Please use our online Product registration form to register your Genie. Can I register my Genie product online Yes. You can also refer to your owner’s manual for further instructions. Test by entering your PIN and pressing the UP/DOWN arrow key once. Battery backups are also available for certain model Genie garage door openers, these allow you to continue to use the garage door opener during a power outage. ![]() Wait 30 seconds until the LED turns off.On the wireless keypad, enter your PIN and press the UP/DOWN arrow key 3, 4, or 5 times until the door activates.Older Genie ACSCTG remotes had numbers on the back that included B8QACSCT, B8Q315390T, TBSTG Type1 (this remote can replace them). Use an existing remote to unlock the system by pressing it once only. Can replace the discontinued style ACSCTG Type 1 Intellicode® remote, ACSCTG Type 2 Intellicode® remote, and the ACSCTG Type 3 Intellicode® remote.Press the square PROGRAM button and release again.(Note: If the round, blue LED turns off and the long, purple light starts blinking, go to the instructions for Intellicode 2 below.) Press and hold the square PROGRAM button located on the bottom of the motor unit, until both the round and cylindrical LEDs turn blue.If your door opener does not have an antenna, you have an external receiver, and you'll need to remove the external receiver cover to find the LEARN CODE button and the indicator LED. ![]() It is usually behind the light bulb cover, close to the antenna wire.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |